The Digital Adapter kit has been added to the case so that some functions can be used with the ubitx.
The digital adapter has:
- 2 stereo Connectors 2.5 mm. These connectors are for any use that you may find .
- USB connector. This could be very useful as it could be used to upgrade the software of your ubitx by just plugging a usb cable from your pc to your rig.
- DB9 connector. This can be used again for any other use you can find of. Some old computers have a db9 which can be used here for CW operating from a pc software , or any other use,it could also be used for Ian Lees code for adding switches with a 20X4 LCD .
Now lets construct the Digital Adapter kit which has the following accessories .
Digital adapter kit. Pcb, 2 nos stereo sockets 2.5mm,db9 connector, usb connector.
Solder stereo sockets, usb connector, D9 on the board. Also solder the micro usb cable as in picture.
Solder the micro usb cable as per wire sequence of colors as in Picture. Black. Red. White. Green. Red is for +vcc. Black is negative and white and green are for Data.
If the adapter does not work then interchange the white and green data wires.
Fully built digital adapter with micro usb cable.
Glue can be spread on the cable to secure it.
Connecting the digital board with ubitx and pc. An additional usb to usb cable will be required to connect the digital adapter to the pc.
Digital board complete and mounted on the rear panel.